Product page

RC Car BMT 984EVO On/Road Kit

BMT984EVO

New product

RC Car BMT 984EVO On/Road Kit 

€ 379,00

-€ 170,00

€ 549,00

RC Car BMT 984EVO On/Road Kit 

BMT launch a new version full optional of 1/8 On/Road Car.

 

Based on new EVO Chassis, the kit include all optional parts produced.

 

PA0089-1 Adjustable Servo Saver
PA0104H Hard Rear Hub
PA0106H Hard Rear Wheel Axle
PA0129-2 EVO Chassis
PA0189LH Hard Steering Block Left
PA0189RH Hard Steering Block Right
PA0194H Hard Front Wheel Axle (2pcs)
PA0203-1 Front Shock Mount “Narrow”
PA0204-1 Upper Deck “Closed”
PA0234A Aluminium Clutch Bell

The latest model car from BMT for 1/8 On / Road is finally available!

The BMT 984EVO is supplied in kit form , disassembled.
To complete the kit requires a 2-channel radio control , a .21 engine . and accessories for the ignition.

Great attention has been given to the ultra-low center of gravity , one of the lowest in the category due to the shape of the tank and the disposal of the servos who are both lying down, where it was specially designed for this unique support that incorporates all the electronics that with only 3 screws out of the model is to facilitate maintenance operations .

Lightweight , everything has been reduced where possible, then the transmission is very light and smooth, the 2-speed change is also small and light, and have the 0.80 module, this translates into greater engine performance , better braking and reduced fuel consumption.

The front and rear suspensions are equipped with Alu bulckhead for strength , and all plastics except the front hub can be mounted both left and right, with a great saving on parts to buy. 

Up front is arranged accommodation for the bar wire, the standard dotation is the classic version with blade. 

The suspensions have the ability to adjust the camber , toe in, wheelbase , so fast through the ball joints present. 

Great care has been given to the construction of the frame , which has been done to ensure equal asymmetrical twist to the left and right side . 

Radio Plate have the bushings included in the kit for flex system . 
The servo saver, brake lever , radio plate support , etc. is in alu. the car isreally full optional. 

The radio plate plates, dampers support and other plate are made in carbon fiber.
The clutch is Centax in version "Reverse" that make the operation of the engine better.

The body supports are in alu, and are eccentric, so as to vary the position of the body quickly . 

Technical data:

Category: 1/8 On -road
Transmission: belt 4wd
Gearbox: 2-speed
Clutch: Adjustable centax
Supports adjustable bodywork
Adjustable anti-roll bars
Fully adjustable suspension
Ventilated disc brake
Low center of gravity
Radio plate and shock absorbers support made in carbon fiber
chassis in Alu 5mm
125ml tank with built-in filter
Dual Tensioner Belt Side
All Transmission with ball beargins

Related Products